Displaying Radio Profile Information; Displaying Map Status Information - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

162 C 6: C
HAPTER ONFIGURING
Displaying Radio
Profile Information
WX1200# display radio-profile default
Beacon Interval:
Max Tx Lifetime:
RTS Threshold:
Short Retry Limit:
Long Preamble:
Tune Channel:
Tune Channel Interval:
Client Backoff Timer:
Service profiles: default-dot1x, default-clear
Displaying MAP
Status Information
MAP A P
CCESS OINTS
To display information for service profile
command:
WX1200# display service-profile wpa_clients
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
(For information about the fields in the output, see the
Switch and Controller Command
To display radio profile information, use the following command:
display radio-profile {name | ?}
Entering display radio-profile ? displays a list of radio profiles.
To display radio profile information for the default radio profile, type the
following command:
100 DTIM Interval:
2000 Max Rx Lifetime:
2346 Frag Threshold:
5 Long Retry Limit:
NO Allow 802.11g clients only:
no Tune Power:
3600 Tune Power Interval:
10 Channel Holddown:
(For information about the fields in the output, see the
Switch and Controller Command
To display status information including link state and WX status, use the
following commands:
display ap status [port-list | all [radio {1 | 2}]]
display dap status [dap-num [radio {1 | 2}]]
wpa_clients,
3Com ssid-type:
yes auth-fallthru:
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
NO
Reference.)
Reference.)
type the following
crypto
web-auth
<none>
<none>
1
Wireless LAN
1
2000
2346
5
NO
no
600
300
Wireless LAN