Configuring Wpa - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

174 C 7: C
HAPTER ONFIGURING

Configuring WPA

U E
SER NCRYPTION
Table 18 lists the encryption support for WPA and non-WPA clients.
Table 18 Encryption Support for WPA and Non-WPA Clients
Client Encryption Type
MSS
Encryption WPA —
Type CCMP
Supports
WPA —
CCMP
Supports
WPA —
TKIP
WPA —
WEP40
WPA —
WEP104
Dynamic
WEP
Static
WEP
To configure MAP access point radios to support WPA:
1 Create a service profile for each SSID that will support WPA clients.
2 Enable the WPA IE in the service profile.
3 Enable the cipher suites you want to support in the service profile. (TKIP is
enabled by default.) Optionally, you also can change the
countermeasures timer value for TKIP.
4 Map the service profile to the radio profile that will control IEEE settings
for the radios.
5 Assign the radio profile to the radios and enable the radios.
If you plan to use PSK authentication, you also need to enable this
authentication method and enter an ASCII passphrase or a hexadecimal
(raw) key.
Creating a Service Profile for WPA
Encryption parameters apply to all users who use the SSID configured by
a service profile. To create a service profile, use the following command:
set service-profile name
WPA — WPA —
TKIP WEP40
Supports
Supports
WPA — Dynamic
WEP104 WEP
Supports
Supports Supports
Supports
Static
WEP
Supports
Supports