Service Profiles - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

(To configure a load-balancing group, see "Configuring a Load-Balancing
Group" on page 144.)

Service Profiles

A service profile controls advertisement and encryption for an SSID. You
can specify the following:
Table 9 lists the parameters controlled by a service profile and their
default values.
Table 9 Defaults for Service Profile Parameters
Whether SSIDs that use the service profile are beaconed
Whether the SSIDs are encrypted or clear (unencrypted)
For encrypted SSIDs, the encryption settings to use
The fallthru authentication method for users that are not
authenticated with 802.1X or MAC authentication
Parameter
auth-dot1x
auth-fallthru
auth-psk
beacon
cipher-ccmp
cipher-tkip
cipher-wep104
Radio Behavior When Parameter
Default Value Set to Default Value
enable When the Wi-Fi Protected Access
(WPA) information element (IE) is
enabled, uses 802.1X to authenticate
WPA clients.
web-auth Uses WebAAA for users who do not
match an 802.1X or MAC
authentication rule for the SSID
requested by the user.
disable Does not support using a preshared key
(PSK) to authenticate WPA clients.
enable Sends beacons to advertise the SSID
managed by the service profile.
disable Does not use Counter with Cipher
Block Chaining Message
Authentication Code Protocol (CCMP)
to encrypt traffic sent to WPA clients.
enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP)
to encrypt traffic sent to WPA clients.
disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt
traffic sent to WPA clients.
MAP Overview 129