Upgrading The Pse Processing Software Online; Displaying Poe Information; Configuration Example - 3Com Switch 4500 26-Port Configuration Manual

Upgrading the PSE
Processing Software
Online
Displaying PoE
Information

Configuration Example

The online upgrading of PSE processing software can update the processing
software or repair the software if it is damaged. After upgrading files are
downloaded, you can use the following command to perform online upgrading
on the PSE processing software.
Perform the following configuration in system view.
Table 73 Upgrading PSE Processing Software Online
Operation
Update PSE Processing Software
Refresh PSE Processing Software
Upgrading in Refresh Mode
Normally, the online upgrading of PSE processing software should be done in
mode.
refresh
Upgrading in Full Mode
When the upgrading procedure in
■
unexpected reason (for example, power-off) or some error occur, you can use
the mode to re-upgrade.
full
When the PSE processing software is damaged (that is, all the PoE commands
■
cannot be successfully executed), you can use the
restore the software.
After the above configuration, execute the
the operation of the PoE feature on the switch and verify the effect of the
configuration.
Table 74 PoE Information Display
Operation
Display the PoE status of a specific port or all
ports on the Switch
Display the PoE power information of a specific
port or all ports on the Switch
Display the PSE parameters
For more information on the parameters, refer to the Command Reference Guide.
Networking Requirements
The Ethernet1/0/1 and Ethernet1/0/2 ports of the Switch 4500 PWR are connected
with a PD and an access point (AP) respectively.
The Ethernet1/0/24 port is intended to be connected with an AP. The PSE
processing software of the Switch 4500 PWR should be first upgraded online. The
remotely accessed PDs should be powered by the Switch 4500 PWR. The power
consumption of the AP that has already been connected with Ethernet1/0/2 is
2500 mW, and the power consumption of the PSU is 12000 mW. This is required
PoE Configuration
Command
poe update full
poe update refresh
mode is interrupted for some
refresh
mode to upgrade and
full
command in any view to see
display
Command
display poe interface [
interface-name | interface-type |
interface-num ]
display poe interface power [
interface-name | interface-type |
interface-num ]
display poe powersupply
77