3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 88

88 C 4: C
HAPTER ONFIGURING AND
M IP I
ANAGING NTERFACES AND
To display the Telnet server status and the TCP port number on which a
WX switch listens for Telnet traffic, type the following command:
WX1200> display ip telnet
Server Status
----------------------------------
Enabled
Changing the Telnet Service Port Number
To change the TCP port the WX switch listens on for Telnet connections,
use the following command:
set ip telnet port-num
CAUTION: If you change the Telnet port number from a Telnet session,
MSS immediately ends the session. To open a new management session,
you must Telnet to the switch with the new Telnet port number.
Resetting the Telnet Service Port Number to Its Default
To reset the Telnet management service to its default TCP port, use the
following command:
clear ip telnet
Managing Telnet Server Sessions
Use the following commands to manage Telnet server sessions:
display sessions admin
clear sessions admin telnet [session-id]
These commands display and clear management sessions from a remote
client to the WX switch's Telnet server.
If you type the clear sessions admin telnet command from within a
Telnet session, the session ends as soon as you press Enter.
To display the Telnet server sessions on a WX switch, type the following
command:
WX1200# display sessions admin
Tty Username
------- --------------------
tty0
tty2 tech
tty3 sshadmin
S
ERVICES
Port
3
Time (s)
--------
3644
6
381
Type
----
Console
Telnet
SSH