3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 130

130 C 6: C
HAPTER ONFIGURING
MAP A P
CCESS OINTS
Table 9 Defaults for Service Profile Parameters (continued)
Parameter
cipher-wep40
psk-phrase
psk-raw
rsn-ie
shared-key-auth
ssid-name
ssid-type
tkip-mc-time
web-aaa-form
wep key-index
wep
active-multicast-index
wep
active-unicast-index
wpa-ie
Radio Behavior When Parameter
Default Value Set to Default Value
disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
No passphrase Uses dynamically generated keys rather
defined than statically configured keys to
authenticate WPA clients.
No preshared Uses dynamically generated keys rather
key defined than statically configured keys to
authenticate WPA clients.
disable Does not use the RSN IE in transmitted
frames.
disable Does not use shared-key
authentication.
This parameter does not enable PSK
authentication for WPA. To enable PSK
encryption for WPA, use the
set radio-profile auth-psk command.
3Com Uses the SSID name 3Com.
crypto Encrypts wireless traffic for the SSID.
60000 Uses Michael countermeasures for
60,000 ms (60 seconds) following
detection of a second MIC failure
within 60 seconds.
Not configured For WebAAA users, serves the default
login web page or, if configured, the
SSID-specific login web page.
No keys defined Uses dynamic WEP rather than static
WEP.
Note: If you configure a WEP key for
static WEP, MSS continues to also
support dynamic WEP.
1 Uses WEP key 1 for static WEP
encryption of multicast traffic if WEP
encryption is enabled and keys are
defined.
1 Uses WEP key 1 for static WEP
encryption of unicast traffic if WEP
encryption is enabled and keys are
defined.
disable Does not use the WPA IE in transmitted
frames.