Configuring Load-Sharing Port Groups - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

60 C 3: C
HAPTER ONFIGURING AND
Port Status
===============================================================================
1 Up
...
Port Status
===============================================================================
1 Up
...
Configuring
Load-Sharing Port
Groups
M P
ANAGING ORTS AND
Table 7 Key Controls for Monitor Port Counters Display
Key
Spacebar
Esc
c
To monitor port statistics beginning with octet statistics (the default),
type the following command:
WX1200# monitor port counters
As soon as you press Enter, MSS clears the window and displays statistics
at the top of the window. In this example, the octet statistics are
displayed first.
To cycle the display to the next set of statistics, press the Spacebar. In this
example, packet statistics are displayed next:
Rx Unicast Rx NonUnicast
54620
(For information about the fields in the output, see the
Switch and Controller Command
A port group is a set of physical ports that function together as a single
link and provide load sharing and link redundancy. Only network ports
can participate in a port group.
You can configure up to 8 ports in a port group, in any combination of
ports. The port numbers do not need to be contiguous and you can use
10/100 Ethernet ports and gigabit Ethernet ports in the same port group.
VLAN
S
Effect on monitor display
Advances to the next statistics type.
Exits the monitor. MSS stops displaying the statistics and
displays a new command prompt.
Clears the statistics counters for the currently displayed
statistics type. The counters begin incrementing again.
Rx Octets
27965420
62144
Reference.)
Tx Octets
34886544
Tx Unicast Tx NonUnicast
68318
Wireless LAN
62556