Table of Contents
Advertisement
WX1200# set system countrycode US
success: change accepted.
WX1200# display system
===============================================================================
Product Name:
System Name:
System Countrycode: US
System Location:
System Contact:
System IP:
System MAC:
===============================================================================
Boot Time:
Uptime:
===============================================================================
Fan status:
Temperature: temp1 ok
PSU Status:
Memory:
Total Power Over Ethernet : 32.000
===============================================================================
Configuring MAP Port
Parameters
WX1200
WX1200
30.30.30.2
00:0B:0E:02:76:F6
2003-05-07 08:28:39
0 days 04:00:07
fan1 OK fan2 OK fan3 OK
temp2 ok
Lower Power Supply DC ok AC ok
115.09/496.04 (23%)
To configure a WX switch for connection to a MAP access point, you
must do one of the following:
For a MAP access point directly connected to a WX switch port,
configure the WX switch port as a MAP access port. ("Setting the Port
Type for a Directly Connected MAP" on page 140.)
For a MAP access point indirectly connected to a WX switch through
an intermediate Layer or Layer network, configure a Distributed AP on
the WX switch. ("Configuring an Indirectly Connected MAP" on
page 142.)
Optionally, you also can change other parameters that affect the entire
MAP:
MAP name. (See "Changing MAP Names" on page 144.)
Dual-home bias. (See "Changing Bias" on page 144.)
Load-balancing group. (See "Configuring a Load-Balancing Group"
on page 144.)
Automatic firmware upgrade capability. (See "Disabling or Reenabling
Automatic Firmware Upgrades" on page 145.)
LED blink mode. (See "Enabling LED Blink Mode" on page 145.)
temp3 ok
Upper Power Supply missing
Configuring MAP Access Points
139
Advertisement
Table of Contents
