3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 186

186 C 7: C
HAPTER ONFIGURING
WX1200# set ap 5,6 radio 1 radio-profile rp1 mode enable
success: change accepted.
WX1200# set ap 6 radio 2 radio-profile rp1 mode enable
success: change accepted.
WX1200# display ap config
Port 5: AP model: mp-241, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11a, mode:
tx pwr: 1, profile: rp1
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Port 6: AP model: mp-252, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode:
tx pwr: 1, profile: rp1
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp1
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
U E
SER NCRYPTION
WX1200# display service-profile wpa
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
6 Map service profile wpa to radio profile rp1. Type the following
commands:
WX1200# set radio-profile rp1 service-profile wpa
success: change accepted.
7 Apply radio profile rp1 to radio 1 on port 5 and to radios 1 and 2 on port
6, enable the radios, and verify the configuration changes. Type the
following commands:
enable, bias: high, name: MAP05
enabled, channel: 36
enable, bias: high, name: MAP11
enabled, channel: 6
8 Save the configuration. Type the following command:
WX1200# save config
success: configuration saved.
mycorp ssid-type:
yes auth-fallthru: last-resort
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
NO
crypto
<none>
<none>
1