Table of Contents
Advertisement
Changing the
Minimum Transmit
Data Rate
Displaying
RF Auto-Tuning
Information
Displaying
RF Auto-Tuning
Settings
For example, to change the max-retransmissions threshold to 20 percent
for radio 1 on the directly connected MAP access port on port 6, type the
following command:
WX1200# set ap 6 radio 1 auto-tune max-retransmissions 20
success: change accepted.
By default, a radio does not lower the transmit data rate for any client
below the following values:
5.5 Mbps for 802.11b/g clients
24 Mbps for 802.11a clients
To change the minimum transmit data rate for 802.11b/g clients or
802.11a clients, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} auto-tune
min-client-rate rate
The rate can be one of the following:
For 802.11g radios — 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1
For 802.11b radios — 11, 5.5, 2, or 1
For 802.11a radios — 54, 48, 36, 24, 18, 12, 9, or 6
To increase the minimum data rate on radio 1, which is an 802.11b/g
radio on the MAP access port on port 6, to 11 Mbps, type the following
command.
WX1200# set ap 6 radio 1 min-client-rate 11
success: change accepted.
You can display the RF Auto-Tuning configuration, a list of RF neighbors,
and the values of RF attributes.
(For information about the fields in the output, see the
Switch and Controller Command
To display the RF Auto-Tuning settings that you can configure in a radio
profile, use the following command:
display radio-profile {name | ?}
Entering display radio-profile ? displays a list of radio profiles.
Displaying RF Auto-Tuning Information
Reference.)
201
Wireless LAN
Advertisement
Table of Contents
