Table of Contents
Advertisement
52
C
3: C
M
P
VLAN
HAPTER
ONFIGURING AND
ANAGING
ORTS AND
S
The serial ID of the AP2750, AP7250, AP8250, or AP8750 might be
preceded by 4 digits and a slash (example: 0100/). Do not enter these
digits or the slash.
The model and radiotype parameters have the same options as they do
with the set port type ap command. Because the WX switch does not
supply power to an indirectly connected MAP, the set dap command
does not use the poe parameter.
To configure Distributed MAP connection 2 for MAP model AP2750 with
serial-ID M9DE48B123400 and radio type 802.11a, type the following
command:
WX1200# set dap 2 serial-id M9DE48B123400 model ap2750
radiotype 11a
success: change accepted.
Setting a Port for a Wired Authentication User
To set a port for a wired authentication user, use the following
command:
set port type wired-auth port-list [tag tag-list]
[max-sessions num]
You must specify a port list. Optionally, you also can specify a tag-list to
subdivide the port into virtual ports, and set the maximum number of
simultaneous user sessions that can be active on the port. By default, one
user session can be active on the port at a time.
To set port 3 as a wired authentication port, type the following
command:
WX1200# set port type wired-auth 3
success: change accepted
This command configures port 3 as a wired authentication port
supporting one interface and one simultaneous user session.
If clients are connected to a wired authentication port through a
downstream third-party switch, the WX switch attempts to authenticate
based on any traffic coming from the switch, such as Spanning Tree
Protocol (STP) BPDUs. In this case, disable repetitive traffic emissions such
as STP BPDUs from downstream switches. If you want to provide a
management path to a downstream switch, use MAC authentication.
Advertisement
Table of Contents
