Changing Tunneling Affinity; Displaying Vlan Information - 3Com 3CRWX120695A, 3CRWX440095A Configuration Manual

Changing Tunneling
Affinity
Displaying VLAN
Information
WX1200# display vlan config burgundy
VLAN Name
---- ---------------- ------ ----- ----- ---------------- ----- -----
2 burgundy
4094 web-aaa
To clear port 6, which uses tag value 11, from VLAN marigold, type the
following command:
WX1200# clear vlan marigold port 6 tag 11
This may disrupt user connectivity.
Do you wish to continue? (y/n) [n]y
success: change accepted.
To completely remove VLAN ecru, type the following command:
WX1200# clear vlan ecru
This may disrupt user connectivity.
Do you wish to continue? (y/n) [n]y
success: change accepted.
You cannot remove the default VLAN (VLAN 1). However, you can add
and remove ports. You can also rename the default VLAN, but 3Com
recommends against it.
To change the tunneling affinity, use the following command:
set vlan vlan-id tunnel-affinity num
Specify a value from 1 through 10. The default is 5.
To display VLAN configuration information, use the following command:
display vlan config [vlan-id]
To display information for VLAN burgundy, type the following command:
Admin VLAN Tunl
Status State Affin Port
Up Up
Up Up
The display can include MAP access ports and wired authentication ports,
because MSS dynamically adds these ports to a VLAN when handling user
traffic for the VLAN.
Configuring and Managing VLANs
5
2
3
4
6
0
2
Port
Tag State
none Up
none Up
none Up
none Up
4094 Up
69