3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 104

104 C 4: C
HAPTER ONFIGURING AND
===============================================================================
WX1200# set ip route default 10.20.10.1 1
success: change accepted.
WX1200# display ip route
Router table for IPv4
Destination/Mask
__________________ _______ ______ _______ _______________ _______________
0.0.0.0/ 0 Static
10.10.10.10/24 IP
10.10.10.10/32 IP
10.20.10.10/24 IP
10.20.10.10/32 IP
224.0.0.0/ 4
WX1200# set timezone PST -8
success: change accepted.
WX1200# display timezone
Timezone is set to 'PST', offset from UTC is -8:0 hours.
WX1200# set summertime PDT
success: change accepted.
M IP I
ANAGING NTERFACES AND
3 Configure a default route through a gateway router attached to the WX
switch and verify the configuration change. Type the following
commands:
Proto Metric NH-Type Gateway
1 Router
0 Direct
0 Local
0 Direct
0 Local
IP 0 Local
4 Configure the DNS domain name and DNS server entries, enable the DNS
service, and verify the configuration changes. Type the following
commands:
WX1200# set ip dns domain example.com
success: change accepted.
WX1200# set ip dns server 10.10.10.69 PRIMARY
success: change accepted.
WX1200# set ip dns server 10.20.10.69 SECONDARY
success: change accepted.
WX1200# set ip dns enable
success: change accepted.
WX1200# display ip dns
Domain Name: example.com
DNS Status: enabled
IP Address
-----------------------------------
10.10.10.69
10.20.10.69
5 Configure time zone, summertime, and NTP parameters and verify the
configuration changes. Type the following commands:
S
ERVICES
VLAN:Interface
10.20.10.1
vlan:1:ip
vlan:1:ip:10.10.10.10/24
vlan:1:ip
vlan:1:ip:10.20.10.10/24
MULTICAST
Type
PRIMARY
SECONDARY