Displaying Poe Profile Configuration - 3Com 4200G 12-Port Configuration Manual

Configure
the relevant
features in
PoE profile
Quit system view
Apply the
existing PoE
profile to the
specified
Ethernet port
Note the following during the configuration:
1) When the apply poe-profile command is used to apply a PoE profile to a port, some PoE features in
the PoE profile can be applied successfully while some cannot. PoE profiles are applied to Switch
4200G according to the following rules:
When the apply poe-profile command is used to apply a PoE profile to a port, the PoE profile is
applied successfully only if one PoE feature in the PoE profile is applied properly. When the
display current-configuration command is used for query, it is displayed that the PoE profile is
applied properly to the port.
If one or more features in the PoE profile are not applied properly on a port, the switch will prompt
explicitly which PoE features in the PoE profile are not applied properly on which ports.
The display current-configuration command can be used to query which PoE profile is applied to
a port. However, the command cannot be used to query which PoE features in a PoE profiles are
applied successfully.

Displaying PoE Profile Configuration

To do...
Display the detailed information
about the PoE profiles created
on the switch
To do...
Enable the PoE feature
on a port
Configure PoE mode
for Ethernet ports
Configure the PoE
priority for Ethernet
ports
Configure the maximum
power for Ethernet
ports
In system view
Enter
Ethernet
port view
In
Apply the
Ethernet
existing
port view
PoE
profile to
the port
display poe-profile { all-profile |
interface interface-type interface-number |
name profile-name }
Use the command...
poe enable
poe mode { signal | spare }
poe priority { critical | high | low }
poe max-power max-power
quit
apply poe-profile profile-name
interface interface-type
interface-number [ to
interface-type interface-number ]
interface interface-type
interface-number
apply poe-profile profile-name
Use the command...
2-2
Remarks
Required
Disabled by default.
Optional
signal by default.
Optional
low by default.
Optional
15,400 mW by
default.
—
Use either
approach.
Remarks
Available in any
view