Table of Contents
Advertisement
11 Display the WPA configuration changes. Type the following command:
12 Map service profile wpa-wep-for-mac to radio profile rp3. Type the
13 Apply radio profile rp3 to radio 1 on port 4 and to radios 1 and 2 on port
WX1200# set ap 4,6 radio 1 radio-profile rp3 mode enable
success: change accepted.
WX1200# set ap 6 radio 2 radio-profile rp3 mode enable
success: change accepted.
WX1200# display ap config
Port
4: AP model: MP-241, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11a, mode:
tx pwr:
1, profile: rp3
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Port
6: AP model: mp-252, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode:
tx pwr:
1, profile: rp3
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr:
1, profile: rp3
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
WX1200# display service-profile wpa-wep-for-mac
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Long Preamble:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: pre-shared key
TKIP countermeasures time: 60000ms
pre-shared-key: 92f99cd49e186cadee13fda7b2a2bac78975
a5723a4a6b31b5b5395d6b001dbe
following commands:
WX1200# set radio-profile rp3 service-profile wpa-wep-for-mac
success: change accepted.
6 and enable the radios, and verify the configuration changes. Type the
following commands:
enable, bias: high, name: MAP04
enabled, channel: 36
enable, bias: high, name: MAP06
enabled, channel: 6
Encryption Configuration Scenarios
voice
ssid-type:
yes
auth-fallthru: last-resort
<none>
WEP Key 2 value:
<none>
WEP Key 4 value:
1
WEP Multicast Index:
YES
Shared Key Auth:
191
crypto
<none>
<none>
1
NO
Advertisement
Table of Contents
