Displaying Poe Profile Configuration - 3Com 4210 PWR Configuration Manual

348 C 32: P E P
HAPTER O
Displaying PoE Profile
Configuration
C
ROFILE ONFIGURATION
Table 270 Configure PoE profile
Operation
Apply the In system view
existing PoE
profile to the
specified
Ethernet port
In Ethernet
port view
Note the following during the configuration:
1 When the apply poe-profile command is used to apply a PoE profile to a port,
some PoE features in the PoE profile can be applied successfully while some
cannot. PoE profiles are applied to the Switch 4210 according to the following
rules:
When the apply poe-profile command is used to apply a PoE profile to a port,
■
the PoE profile is applied successfully only if one PoE feature in the PoE profile
is applied properly. When the display current-configuration command is
used for query, it is displayed that the PoE profile is applied properly to the port.
If one or more features in the PoE profile are not applied properly on a port, the
■
switch will prompt explicitly which PoE features in the PoE profile are not
applied properly on which ports.
The display current-configuration command can be used to query which
■
PoE profile is applied to a port. However, the command cannot be used to
query which PoE features in a PoE profiles are applied successfully.
2 PoE profile configuration is a global configuration, and applies synchronously in
the intelligent resilient framework (IRF) system.
3 Combination of Unit creates a new Fabric. In the newly created Fabric, the PoE
profile configuration of the Unit with the smallest Unit ID number will become the
PoE profile configuration for the Fabric currently in use.
4 Split of Fabric results in many new Fabrics. In each newly created Fabric, the PoE
profile configuration of each Unit remains the same as it was before the split.
After the above configuration, execute the display command in any view to see
the running status of the PoE profile and verify the effect of the configuration by
checking the displayed information.
Table 271 Display the PoE profile configuration
Operation
Display the detailed information
about the PoE profiles created
on the switch
Command
apply poe-profile
profile-name interface
interface-type
interface-number [ to
interface-type
interface-number ]
Enter interface interface-type
Ethernet interface-number
port view
Apply the apply poe-profile
existing PoE profile-name
profile to the
port
Command
display poe-profile { all-profile |
interface interface-type
interface-number | name
profile-name }
Description
Use either
approach.
Description
Available in any view