Copying Trace Results
to a Server
Clearing the Trace
List of Trace Areas
WX1200# display log trace facility ?
<facility name>
SYSLOGD, ACL, APM, ARP,ASO, BOOT, CLI,
CLUSTER, COPP, CRYPTO, DOT1X, ENCAP,
ETHERNET, GATEWAY, HTTPD, IGMP, IP,
MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM,
ROGUE, SM, SNMPD, SPAN, STORE, SYS,
TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP,
TLS, TUNNEL, VLAN, X509, XML, MAP, RAPDA,
WEBVIEW, EAP, PORTCONFIG, FP.
To copy the contents of the trace buffer to a file on a TFTP server, use the
following command:
copy trace-buffer-name tftp://[destination-ip-addr |
destination-hostname]/destination-filename
To find the name of the trace buffer file, use the dir command.
For example, the following command copies the log messages in trace
buffer 0000000001 to a TFTP server at IP address 192.168.253.11, in a
file called log-file:
WX1200# copy 0000000001 tftp://192.168.253.11/log-file
To clear all messages from the trace log buffer, type the following
Log
command:
WX1200# clear log trace
To see all MSS areas you can trace, type the following command:
WX1200# set trace ?
Table 40 lists the names of MSS areas that are displayed. You can enter
any of these names in place of area in the set trace command.
Table 40 MSS Areas Displayed With the set trace Command
aaacli
ap_buffer_mgr
ap_station
apm_trap
Select one of: KERNEL, AAA,
accounting
acl
ap_crypto
ap_ethernet
ap_stats
ap_tapa
arp
authentication
Running Traces
ams
ag_agent
ap_network
ap_radio
ap_util
ap_vlan
authorization
cli
417