Table of Contents
Advertisement
WX1200# display rfdetect data
Total number of entries: 7
BSSID
-----------------
00:06:25:09:39:4a
00:06:25:51:e9:ff
00:06:25:51:e9:ff
00:0b:0e:00:00:00
00:0b:0e:00:02:00
00:0b:0e:00:02:00
00:0b:0e:00:02:01
Displaying the
Devices By a Specific
Radio
Port/Rad
Chan
--------
------
5/1
4/1
5/1
4/1
4/1
5/1
4/1
To display the devices detected by a specific MAP radio, use the following
command:
display rfdetect visible mac-addr
display rfdetect visible ap mp-num [radio {1 | 2}]
display rfdetect visible dap dap-num [radio {1 | 2}]
The mac-addr is the base MAC address of the 3Com MAP radio. The
mp-num or dap-num is the MAP port or Distributed MAP that has the
radio.
To display the base MAC address of a 3Com radio, use the
display {ap | dap} status command.
These commands list all transmitting devices, including other 3Com
radios and devices in the known addresses list as well as rogues. If a
3Com radio is supporting more than one SSID, each of the corresponding
BSSIDs is listed separately.
You can enter this command on any WX switch in the Mobility Domain.
The command shows only the devices detected by that switch.
The following command displays the devices detected by 3Com radio
00:0b:0e:00:0a:6a:
WX1200# display rfdetect visible 00:0b:0e:00:0a:6a
Total number of entries: 4
Transmit MAC
-----------------
00:0b:0e:00:02:01
00:0b:0e:00:03:41
00:0b:0e:00:0b:01
00:0b:0e:ff:00:01
Displaying RF Detection Information
RSSI Age SSID
---- --- --------
3
0
15 rack29ap
10
-85
15 Arrow
10
-84
15 Arrow
1
-78
15 gary-eng
11
-76
15 public
11
-74
15 public
56
-68
15 public
Chan
--------
-------
56
36
52
36
RSS
-74
-44
-79
-84
385
Advertisement
Table of Contents
