Table of Contents
Advertisement
394
C
18: M
HAPTER
corp_a/
file:dangcfg
dangdir/
old/
Total:
===============================================================================
Boot:
Filename
*boot0:bload
*boot0:WXB03002.Rel
boot1:WXB03001.Re1
Boot0: Total:
Boot1: Total:
===============================================================================
temporary files:
Filename
Total:
Removing a
Subdirectory
Managing
Configuration Files
S
F
ANAGING
YSTEM
ILES
33 Kbytes used, 207822 Kbytes free
8928 Kbytes used, 3312 Kbytes free
8197 Kbytes used, 4060 Kbytes free
0 bytes used, 93537 Kbytes free
To remove a subdirectory from nonvolatile storage, use the following
command:
rmdir [subdirname]
To remove subdirectory corp2, type the following example:
WX1200# rmdir corp2
success: change accepted.
A configuration file contains CLI commands that set up the WX switch.
The switch loads a designated configuration file immediately after
loading the system software when the software is rebooted. You also can
load a configuration file while the switch is running to change the
switch's configuration.
When you enter CLI commands to make configuration changes, these
changes are immediately added to the device's running configuration but
are not saved to the configuration file.
This section describes how to display the running configuration and the
configuration file, and how to save and load configuration changes. A
procedure is also provided for resetting the WX switch to its factory
default configuration.
512 bytes
May 21 2004, 19:15:48
13 KB
May 16 2004, 18:30:44
512 bytes
May 16 2004, 17:23:44
512 bytes
Sep 23 2003, 21:58:48
Size
746 KB
May 09 2004, 19:02:16
8182 KB
May 09 2004, 18:58:16
8197 KB
May 21 2004, 18:01:02
Size
Created
Created
Advertisement
Table of Contents
