3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 50

50 C 3: C M P VLAN
HAPTER ONFIGURING AND ANAGING ORTS AND S
You cannot configure any gigabit Ethernet port, or port 7 or 8 on a
WX1200 switch, as a MAP port. To manage a MAP access point on a
WX4400 switch, configure a Distributed MAP connection on the switch.
(See "Configuring for a Distributed MAP" on page 51.)
MAP model MP-262 requires an external antenna for the 802.11b/g
radio. You must specify the antenna model. MAP models MP-341 and
MP-352 have an internal 802.1b/g antenna as well as a connector for an
external antenna, so use of an external antenna is optional on these
models. The MP-372 also has a connector for an optional external
802.11a antenna. To specify the antenna model, use the set {ap | dap}
radio antennatype command. (See "Configuring the External Antenna
Model" on page 156.)
To set ports 4 through 6 for MAP access point model AP2750 and enable
PoE on the ports, type the following command:
WX1200# set port type ap 4-6 model ap2750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.
To set port 3 for MAP access point model AP2750, enable PoE on the
port, and set the radio type to 802.11b only, type the following
command:
WX1200# set port type ap 3 model ap2750 poe enable radiotype
11b
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.
To set port 5 for MAP access point model AP2750, enable PoE on the
port, and change the radio type to 802.11a, type the following
command:
WX1200# set port type ap 5 model ap2750 poe enable radiotype
11a
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.