Table of Contents
Advertisement
202
C
8: C
HAPTER
ONFIGURING
WX1200# display radio-profile default
Beacon Interval:
Max Tx Lifetime:
RTS Threshold:
Short Retry Limit:
Long Preamble:
Tune Channel:
Tune Channel Interval:
Client Backoff Timer:
Service profiles: default-dot1x, default-clear
WX1200# display ap config 2
Port
2: AP model: AP2750, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel:
tx pwr:
1, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
WX1200# display dap config 1
Dap
1: Serial-Id: M9DE48B012F00, AP model: AP2750, bias: high, name: DMP01
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel:
tx pwr:
1, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
RF A
-T
UTO
UNING
To display the RF Auto-Tuning and other settings in the default radio
profile, type the following command:
100
DTIM Interval:
2000
Max Rx Lifetime:
2346
Frag Threshold:
5
Long Retry Limit:
NO
Allow 802.11g clients only:
yes
Tune Power:
3600
Tune Power Interval:
10
Channel Holddown:
To display the RF Auto-Tuning settings that you can configure on an
individual radio, use the following commands:
display ap config [port-list [radio {1 | 2}]]
display dap config [dap-num [radio {1 | 2}]]
To display the RF Auto-Tuning and other individual radio settings on a
directly connected MAP access port connected to WX port 2, type the
following command:
enable, bias: high, name: MAP02
To display the RF Auto-Tuning and other individual radio settings on the
Distributed MAP access point configured on connection 1, type the
following command:
2000
2346
600
300
6
6
1
5
NO
no
Advertisement
Table of Contents
