Administrative AAA
Configuration
Scenarios
Local Authentication
You can also type the load config command, which reloads the WX
switch to the last saved configuration or loads a particular configuration
filename. (For more information, see "Managing Configuration Files" on
page 394.)
The following scenarios illustrate typical configurations for administrative
and local authentication. For all scenarios, the administrator is Natasha
with the password m@Jor. (For RADIUS server configuration details, see
Chapter 14, "Configuring Communication with RADIUS," on page 343.)
"Local Authentication" on page 43
"Local Authentication for Console Users and RADIUS Authentication
for Telnet Users" on page 44
"Local Override and Backup Local Authentication" on page 44
"Authentication When RADIUS Servers Do Not Respond" on page 45
The first time you access a WX switch, it requires no authentication. (For
more information, see "First-Time Configuration via the Console" on
page 36.) In this scenario, after the initial configuration of the WX switch,
Natasha is connected through the console and has enabled access.
To enable local authentication for a console user, you must configure a
local username. Natasha types the following commands in this order:
WX1200# set user natasha password m@Jor
User natasha created
WX1200# set authentication console * local
success: change accepted.
WX1200# save config
success: configuration saved.
Administrative AAA Configuration Scenarios
43