Table of Contents
Advertisement
Tunnel affinity (a value that influences tunneling connections for
roaming)
Creating a VLAN
To create a VLAN, use the following command:
set vlan vlan-num name name
Specify a VLAN number from 2 to 4095, and specify a name up to
16 alphabetic characters long.
VLAN 4094 is reserved for WebAAA.
You cannot use a number as the first character in a VLAN name. 3Com
recommends that you do not use the same name with different
capitalizations for VLANs or ACLs. For example, do not configure two
separate VLANs with the names red and RED.
3Com recommends that you do not use the name default. This name is
already used for VLAN 1. 3Com also recommends that you do not
rename the default VLAN.
You must assign a name to a VLAN before you can add ports to the
VLAN. You can configure the name and add ports with a single set vlan
command or separate set vlan commands.
Once you assign a VLAN number to a VLAN, you cannot change the
number. However, you can change a VLAN's name.
For example, to assign the name red to VLAN 2, type the following
command:
WX1200# set vlan 2 name red
After you create a VLAN, you can use the VLAN number or the VLAN
name in commands. In addition, the VLAN name appears in CLI and
3Com Wireless Switch Manager displays.
Adding Ports to a VLAN
To add a port to a VLAN, use the following command:
set vlan vlan-id port port-list [tag tag-value]
You can specify a tag value from 1 through 4095.
Configuring and Managing VLANs
67
Advertisement
Table of Contents
