3Com 3CRWX120695A, 3CRWX440095A Configuration Manual page 177

?=+&% The quick brown fox jumps over the lazy sl"
success: change accepted.
As an alternative to entering a passphrase, which MSS converts into a
key, you can enter the key itself in raw hexadecimal format. To enter a
PSK key in raw format, use the following command:
set service-profile name psk-raw hex
For hex, type a 64-bit ASCII string representing a 32-digit hexadecimal
number. Enter the two-character ASCII form of each hexadecimal
number.
To configure service profile wpa to use a raw PSK with PSK clients, type a
command such as the following:
WX1200# set service-profile wpa psk-raw c25d3fe4483e867d1df96
eaacdf8b02451fa0836162e758100f5f6b87965e59d
success: change accepted.
Disabling 802.1X Authentication for WPA
To disable 802.1X authentication for WPA clients, use the following
command:
set service-profile name auth-dot1x {enable | disable}
This command does not disable 802.1X authentication for non-WPA
clients.
To disable WPA authentication in service profile wpa, type the following
command:
WX1200# set service-profile wpa auth-dot1x disable
success: change accepted.
Displaying WPA Settings
To display the WPA settings in a service profile, use the following
command:
display service-profile {name | ?}
To display the WPA settings in effect in service profile wpa, type the
following command:
WX1200# display service-profile wpa
ssid-name:
beacon:
3Com ssid-type:
yes auth-fallthru: last-resort
Configuring WPA 177
crypto