Table of Contents
Advertisement
160
C
6: C
HAPTER
ONFIGURING
WX1200# display dap config 1
Dap
1: Serial-Id: M9DE48B012F00, MAP model: AP2750, bias: high, name: DAP1
boot-download-enable: YES
Radio 1: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Displaying a List of
Distributed MAPs
MAP A
P
CCESS
OINTS
To display configuration information for a Distributed MAP access point
configured on connection 1, type the following command:
(For information about the fields in the output, see the
Switch and Controller Command
To display a list of the Distributed MAPs configured on WX switches in
the Mobility Domain, use the following command:
display dap global [dap-num | serial-id serial-ID]
This command lists the System IP addresses of all the WX switches on
which each Distributed MAP is configured, and lists the bias for the MAP
on each switch. For each Distributed MAP that is configured on the
switch on which you use the command, the connection number is also
listed.
To display information for all Distributed MAPs configured on all WX
switches in the Mobility Domain, type the following command:
WX4400# display dap global
Total number of entries: 8
DAP Serial Id
--- -----------
1
M9DE48B012F00 10.3.8.111
-
M9DE48B012F00 10.4.3.2
2
M9DE48B123400 10.3.8.111
-
M9DE48B123400 10.4.3.2
17
M9DE48B123600 10.3.8.111
-
M9DE48B123600 10.4.3.2
18
M9DE48B123700 10.3.8.111
-
M9DE48B123700 10.4.3.2
This command indicates that the Mobility Domain contains four
Distributed MAPs, with serial IDs M9DE48B012F00, M9DE48B123400,
M9DE48B123600, and M9DE48B123700. Each MAP is configured on
two WX switches, with system IP addresses 10.3.8.111 and 10.4.3.2. The
bias for the MAP on each WX switch is listed. Normally, a Distributed
MAP boots from the WX switch with the high bias for the MAP. (For
Reference.)
WX IP Address
Bias
--------------- ----
HIGH
LOW
LOW
HIGH
HIGH
LOW
LOW
HIGH
Wireless LAN
Advertisement
Table of Contents
