Table of Contents
Advertisement
68
C
3: C
M
P
VLAN
HAPTER
ONFIGURING AND
ANAGING
ORTS AND
S
MSS does not remove a port from other VLANs when you add the port to
a new VLAN. If a new VLAN causes a configuration conflict with an older
VLAN, remove the port from the older VLAN before adding the port to
the new VLAN.
For example, to add ports 3 through 6 and port 8 to VLAN red, type the
following command:
WX1200# set vlan red port 3-6,8
success: change accepted.
Optionally, you also can specify a tag value to be used on trunked 802.1Q
ports.
To assign the name marigold to VLAN 4, add ports 1 through 4 and port
6, and assign tag value 11 to port 6, type the following commands:
WX1200# set vlan 4 name marigold port 1-4
success: change accepted.
WX1200# set vlan 4 name marigold port 6 tag 11
success: change accepted.
Removing an Entire VLAN or a VLAN Port
To remove an entire VLAN or a specific port and tag value from a VLAN,
use the following command:
clear vlan vlan-id [port port-list [tag tag-value]]
CAUTION: When you remove a VLAN, MSS completely removes the
VLAN from the configuration and also removes all configuration
information that uses the VLAN. If you want to remove only a specific
port from the VLAN, make sure you specify the port number in the
command.
The clear vlan command with a VLAN ID but without a port list or tag
value clears all ports and tag values from the VLAN.
To remove port 3 from VLAN red, type the following command:
WX1200# clear vlan red port 3
This may disrupt user connectivity.
Do you wish to continue? (y/n) [n]y
success: change accepted.
Advertisement
Table of Contents
