Table of Contents
Advertisement
Clearing a Port
To change a port's type from MAP access port or wired authentication
port, you must first clear the port, then set the port type.
CAUTION: When you clear a port, MSS ends user sessions that are using
the port.
Clearing a port removes all the port's configuration settings and resets
the port as a network port.
If the port is a MAP access port, clearing the port disables PoE and
802.1X authentication.
If the port is a wired authenticated port, clearing the port disables
802.1X authentication.
If the port is a network port, the port must first be removed from all
VLANs, which removes the port from all spanning trees, load-sharing
port groups, and so on.
A cleared port is not placed in any VLANs, not even the default VLAN
(VLAN 1).
To clear a port, use the following command:
clear port type port-list
For example, to clear the port-related settings from port 5 and reset the
port as a network port, type the following command:
WX1200# clear port type 5
This may disrupt currently authenticated users. Are you sure?
(y/n) [n]y
success: change accepted.
Clearing a Distributed MAP
To clear a Distributed MAP, use the following command:
clear dap dap-num
CAUTION: When you clear a Distributed MAP, MSS ends user sessions
that are using the MAP.
Configuring and Managing Ports
53
Advertisement
Table of Contents
