Front Panel Leds; Setting The 804/804A/804B Front Panel Mode - Teledyne 804A User Manual

804 Series Video Test Generator – User Guide
When you finish touch selecting the fourth box, the calibration is completed and you will return to the Home menu.
5.5

Front Panel LEDs

The 804/804A/804B has two LEDs on the front to indicate the status of the Tx and Rx activity of the RS-232 interface. Note
that when you send a command you will see the Tx and Rx lights on the 804/804A/804B front panel flash briefly.
5.6

Setting the 804/804A/804B Front Panel Mode

The 804/804A/804B front panel can be operated in one of two modes: 1) Touch screen mode and 2) 804/804A/804B
Manufacturing (Status only) mode. The Touch Screen mode enables you to fully operate the 804/804A/804B through the
color touch display. The procedures for operating the 804/804A/804B through the front panel are provided in the section
Running Protocol Tests - Using the Front Panel
Typically you would use the Manufacturing (status only) mode when you were operating the 804/804A/804B through the
command line via either a keypad or an automated test system.
Use the following procedure to set the 804/804A/804B front panel display mode.
1. Set the 804/804A/804B display mode to the Touch Screen mode using the following command.
Page 18
GUI.
Revision B3