Problems With Expressbuilder - NEC Express5800/120Rd-2 Service Manual

Problems with EXPRESSBUILDER

When booting from the EXPRESSBUILDER CD fails, check the following:
θ Did you insert the EXPRESSBUILDER CD during POST and restart the server?
→ If you do not insert the EXPRESSBUILDER CD during POST and restart the
server, an error message will appear or the OS will boot.
θ Is BIOS configuration correct?
→ The boot device order is specified in the BIOS setup utility of the server. Use the
BIOS setup utility to change the boot device order to boot the system from the
CD-ROM drive first.
<Menu to check: [Boot]>
θ Is an error message displayed?
→ When an error occurs while the EXPRESSBUILDER is in progress, the following
message appears.
After this message appears, check the error and take the appropriate corrective
action according to the error code listed in the table below.
Error
code
MC
NV
PT
FL
Error occurred.
Error code [XX]
Terminate the program.
Confirm:[Enter]
This EXPRESSBUILDER version is not designed for this server.
Execute EXPRESSBUILDER on the compliant server.
An access to the nonvolatile memory (NvRAM) is allowed.
The hard disk is not connected or has failed.
Check whether the hard disk is connected correctly.
Read from and write to the floppy disk may be disabled.
Replace the floppy disk with new one and execute EXPRESSBUILDER
again.
Cause and Remedy
Troubleshooting 6-19