Problems With Nec Expressbuilder - NEC Express5800 User Manual

8-16 Troubleshooting

Problems with NEC EXPRESSBUILDER

When the CPU blade is not booted from the NEC EXPRESSBUILDER CD-ROM, check the
following:
Did you set the NEC EXPRESSBUILDER during POST and restart the CPU blade?
→ If you do not set the NEC EXPRESSBUILDER during POST and restart the CPU
blade, an error message will appear or the OS will boot.
Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the CPU
blade. Use the BIOS setup utility to change the boot device order to boot the
system from the DVD-ROM drive first.
<Menu to check: [Boot]>
Is an error message appeared?
→ When an error occurs while the NEC EXPRESSBUILDER is in progress, the
following message appears. After this message appears, check the error and take
the appropriate corrective action according to the message listed in the table
below.
This machine is not supported.
NvRAM access error
Hard disk drive access error
Message Cause and Remedy
This NEC EXPRESSBUILDER version is
not designed for this CPU blade. Execute
the NEC EXPRESSBUILDER on the
compliant CPU blade.
An access to the nonvolatile memory
(NvRAM) is not acceptable.
The hard disk drive is not connected or it is
failed.
Check whether the hard disk drive is
correctly connected.