NEC Express5800/120Rd-2 Service Manual page 278

7-34 Disassembly and Reassembly
9. Insert a standard screwdriver into the bracket of the wire clip, and engage the wire clip
with the socket.
Make sure that the heat sink is level.
10.
NOTES:
If the heat sink is not level, remove it, and then install it again. The
!
following probably causes the heat sink not to be level:
– The heat sink is not positioned correctly.
– The wire clip is not engaged correctly.
Do not move the secured heat sink.
!
11. Install the components you removed previously.
Power on the server, start the SETUP utility, and select [Main] → [Processor Settings]
12.
→ [Processor Retest] → [Enabled].
Insert the EXPRESSBUILDER CD into the CD-ROM drive, and start the system
13.
booting from the EXPRESSBUILDER CD.
See the EXPRESSBUILDER User's Guide, located on the EXPRESSBUILDER
CDROM, for details.
14. Diagnose the system.
See the EXPRESSBUILDER User's Guide, located on the EXPRESSBUILDER
CDROM, for details.