Setup For Problem Resolution - NEC Express5800/120Rd-2 Service Manual

4-16 Installing the Operating System

Setup for Problem Resolution

Additional steps should be taken to facilitate the resolution of problems that might occur.
Memory Dump (Debug Information)
This section describes the procedures for collecting memory dump (debug information) in the
server.
IMPORTANT: Memory Dump Information
If any trouble occurs after initiating the process below, a message
stating that the system is short of virtual memory may appear, but
complete the process. If you restart the system the memory dump may
not be stored correctly.
Follow the procedure below to specify.
Point to [Settings] in Start menu and click [Control Panel].
1.
The [Control Panel] dialog box appears.
2. Double-click [System].
The [System Properties] dialog box appears.
3. Click [Advanced].
4. Click [Startup and Recovery].
5. Enter the location to write the debug information in "Dump File" under "Write
Debugging Information.".
e.g. Write the debug information to D drive with the file name "MEMORY.DMP".
D:\MEMORY.DMP