Installing Microsoft Windows 2000 Operating System - NEC Express5800/120Rd-2 Service Manual

C-4 Installing and Configuring Windows 2000 and Windows NT 4.0
Installing Microsoft Windows
Use the following procedure to set up and perform a clean Windows 2000 Operating System installation on your
server.
1.
Insert the Windows 2000 CD into the CD-ROM drive and boot your system by pressing
CTRL+ALT+Delete.
IMPORTANT
installed in your server; go to Step 7 if your server does not include a
RAID controller.
2.
While the message "Setup is inspecting your computer's hardware configuration" or a solid blue
background is displayed on the screen, press the F6 key.
IMPORTANT:
F6 key has been pressed.
3.
When the following message is displayed, press S.
"Setup could not determine the type of one or more mass storage devices installed in your system, or you
have chosen to manually specify an adapter". Currently, Setup will load support for the following mass
storage devices.
4.
When the following message is displayed, select "Other" and then press Enter.
Select the SCSI Adapter your want from the following list, or select "Other" if you have a device support
disk provided by an adapter manufacturer
5.
Insert the "Windows 2000 OEM-DISK" diskette into the floppy drive, and press Enter. A list of mass
storage devices is displayed.
6.
Select the RAID disk array controller installed in your server from the list of mass storage devices.
7.
Follow the messages on the screen to continue to install.
IMPORTANT:
Installation Guide for more extensive installation procedures.
For LAN adapter driver installation, see Installing LAN Adapter Drivers
later in this appendix.
8.
After installing Windows 2000, logon to the system using the administrator account or other account,
which is a member of the Administrator's group.
®
2000 Operating System
: Perform Steps 2 through 6 if a RAID controller is
There is no visible indication on the screen when the
Please consult the Microsoft Windows 2000