NEC Express5800/120Rd-2 Service Manual page 73

Installing the Rail Brackets onto the Sliding Rails
Install a rail bracket onto each sliding rail assembly as shown below.
1.
Line up the screw hole (slot) at the top end of each rail assembly to the screw hole in the
2.
rail bracket, and loosely tighten the screw to temporarily secure the rail assembly and
bracket.
When each rail bracket is installed on the rail assembly, the catch tab at the top end of
3.
the rail bracket should point upwards like the catch tab at the opposite end of the rail
assembly. See the Figure below.
Front side of the rack
Catch
Rail assembly
Screw holes
(Use the screw hole in accordance with
the depth of the rack. Lightly tighten the
screw.)
Setting Up Your Server 2-9
Inner rails
Catch
Rail bracket
Rear side of the rack