Table of Contents
Advertisement
Installation
Perform the following steps to install a hard disk drive. This procedure applies to all the hard
disk drive bays. See the next section for the procedure installing a hard disk drive in the flex bay.
NOTE: Any hard disk can be installed or removed in or from the server
after removing the front bezel.
IMPORTANT: In the disk array configuration, all hard disks in the array
must have the same specifications, including drive capacity.
See the section "Preparing for Installation and Removal" described earlier to prepare.
1.
Unlock the front bezel with the security key and remove the front bezel.
2.
Locate the slot in which you are going to install a hard disk drive.
3.
The server has six slots. Install hard disk drives in ascending order of the SCSI ID
numbers. The SCSI IDs assigned to the slots are all determined.
4.
Release the lock by pushing the dummy tray lever.
Disassembly and Reassembly 7-7
Security lock
Advertisement
Table of Contents
Troubleshooting
