NEC Express5800/120Rd-2 Service Manual page 224

6-22 Troubleshooting
Windows 2000 started with a different display resolution from the specified value.
→ If the specified display resolution can not be used, the system will use the nearest
value or the default value of the driver.
Entered the incorrect Product ID/CD key.
→ Even if you entered the incorrect Product ID/CD key, Express Setup will start.
However, the setup will stop and asks you to re-enter the correct value. Also in this
case, an input request will occur when rebooting after GUI setup is completed during
Express Setup. If these 2 inputs are entered correctly, there is no problem with
Windows 2000 setup.
Unable to configure the properties of the network adapter.
→ In Express Setup, you can not configure the properties of the Network adapter.
Specify them from Control Panel after starting Windows 2000.
Windows 2000 is started with a Network adapter that has not been configured during Express Setup
→ Windows 2000 will install the recognized Network adapter configured as the default
adapter. If you want to modify the properties of this adapter, you can do this from
the Control Panel after starting Windows 2000. Also, a Network adapter that has
been specified during Express Setup, but that is not installed, will not be setup
however the protocol will be installed.
Two or more Network adapters are installed and configured with different protocols for each adapter, but all
the protocols are configured for all adapters.
→ Each adapter is configured so that all the installed protocols can be used.
Values that are not specified during Express Setup will all be specified by the default
value.
When more than two Network adapters are specified, the detailed specification of TCP/IP protocol are all set
to use DHCP.
→ When more than two Network adapters are specified, the detailed specification of the
protocol for all adapters is set by default value. Re-specify the details from Control
Panel.