NEC Express5800/120Rd-2 Service Manual page 190

4-56 Installing the Operating System
24. Log into "Root" and from the "Unix" window issue the following:
"mount -f/dev/fd0/mnt."
"cp/mnt/idscsi/etc/conf/bin"
This concludes the installation of SCO 5.0X UNIX. You need to open the diskette
drive and reboot the SCO 5.0X UNIX operating system from the system drive you
just installed.
Note:
when booting SCO a warning message may appear as follows:
WARNING: Cannot connect to APM, error 0x0036 System loaded,
press <Return> to start:
To prevent the WARNING message from appearing, boot the
system to single-user Mode. Edit the /etc/default/boot file. Add
"apm.check=no" to the end of the line indicated by the
"DEFBOOTSTR=" entry.
It is recommended that any additional software packages be installed at this time.
After all additional software is installed; it is recommended that Maintenance
Supplement 505A be installed on your system.
Note:
policy to write-back until after the installation completes.
Installation of Tape Drives
After the installation of SCO 5.0X UNIX is complete, ensure the tape device is
configured to the proper controller. If reconfiguring is necessary, follow the
instructions in the hardware section of the SCO OpenServer Rel. 5.0X Handbook.
Installation of CD-ROM Drives
Ensure that the CD-ROM device is connected to the proper controller. If
reconfiguring is necessary, follow the instructions in the hardware section of the SCO
OpenServer Rel. 5.0X Handbook.
Adding System Drives
After installing SCO UNIX on system drive 0 (root drive), it may be necessary to
create additional file systems on any other system drives. Use the command "mkdev
hd" to partition and create file systems on additional system drives.
During the installation of SCO or any time thereafter
Do not change the system drive 0 (boot drive) cache