NEC Express5800/120Rd-2 Service Manual page 84

2-20 Setting Up Your Server
To connect the power cord from the server to an interruptive power supply (UPS), use service
outlets on the rear of the UPS.
The UPS service outlets are categorized into two groups: SWITCH OUT and UN-SWITCH
OUT. (They may be called "OUTPUT1" and "OUTPUT2".)
To control a power supply with an application (ESMPRO/UPS Controller) that controls the UPS,
connect the power cord to the SWITCH OUT outlet.
For constant power, connect the power cord to a UN-SWITCH OUT outlet. (Also, connect the
modem that is in continual service to this outlet.)
<Example>
When the power cord from the server is connected into a UPS, change the BIOS setup of the
server to link with power supply to the UPS. Change the parameter for "After Power Failure"
located under the System Hardware menu of the BIOS setup utility. See Chapter 3 for details.
2
O U TP UT
O U TP UT(SW ITC H O UT)
(U NSW ITC H O UT)
AC 100V 50/50H Z
UN-SWITCH OUT
(OUTPUT 2)
SWITCH OUT
(OUTPUT 1)