Removing The Server From The Rack Assembly - NEC Express5800/120Rd-2 Service Manual

2-14 Setting Up Your Server

Removing the Server from the Rack Assembly

At least two persons are required to remove the server from the rack.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Do not attempt to lift the server by yourself. At least two persons are required
to remove the server from the rack.
Do not pinch your finger in the mechanical components.
Do not pull any device out of the rack if the rack is unstable.
Do not pull more than one device out of the rack at one time.
Release the security lock, open and remove the front bezel.
1.
2. Confirm that the server is powered OFF, and disconnect the power cable and all the
interface cables connected to the server.
3. If a cable arm is installed, remove the two screws securing the cable arm to the server
and remove the cable arm from the server.
Loosen the two front thumbscrews securing the server to the rack
4.
5. Holding the handles, slowly and carefully pull the server out of the rack.
A click is heard as the slide rails lock in the extended position.
WARNING
WARNING
Security lock