NEC Express5800/120Rd-2 Service Manual page 192

4-58 Installing the Operating System
Note:
system, the system names for each sub-network must be unique.
9. At the "Product successfully completed" message, select OK.
10. After the configuration is complete and the current networking configuration is
displayed, select Hardware from the menu bar, and then select Exit.
11. At the message the "UNIX kernel must be relinked...", select YES to relink the
kernel.
12. At the message "Do you want this kernel to reboot by default", enter YES and
press ENTER.
13. At the message "Do you want the kernel environment rebuilt", enter YES and
press ENTER.
14. Press ENTER to continue.
15. Reboot your system.
Configuring Additional Hard Disks
Configuring additional hard disk drives requires that they be hardware configured and
low-level formatted (most disks are shipped already low-level formatted).
For SCO UNIX Open System and OpenServer Rel. 5.X Software to recognize more
than one hard disk drive, you must execute a series of commands. For a detailed
description of the commands, refer to the chapter entitled "Adding Hard Disks and
CD-ROM Drivers" in the SCO UNIX Operating System Administrator's Guide or the
SCO Open Systems Rel. 5X Hardware Configuration Guide.
An example of the command sequence is shown below:
Refer to the on-line SCO man page for information on the mkdev (ADM) command.
When configuring multiple sub-networks on the same
SCSI Disks
mkdev hd
(build a kernel)
(reboot the system)
mkdev hd
mkdev fs
mountall