Installing Optional Hardware - NEC Express5800/120Rd-2 Service Manual

4-48 Installing the Operating System
Configuring RAID
If you have a disk array controller preinstalled on your system, it was preconfigured
at the factory. Refer to your system's User's Guide and to the RAID Installation Guide
and the Disk Array Controller Installation Guide and User's Manual for additional
information on this option card. If you need to change the RAID level from the
factory setting, you must change the setting before installing the operating system.

Installing Optional Hardware

This section contains supplemental hardware installation and configuration
information.
Installing Optional Adapters
If you are installing optional adapters, refer to the installation guide that came with
the adapter, the SCO documentation and the System User's Guide shipped with your
system for installation and configuration information.
The following optional adapter may be added to your system.
Disk Array Controller - Refer to your system's User's Guide and to the RAID
Installation Guide and the Disk Array Controller Installation Guide and User's
Manual for additional information on this option card.
Installing Other Hardware
Refer to the Upgrading Your System chapter of your System User's Guide for
installing additional memory, additional hard disk drives or new peripheral devices.
Where to Go From Here
Now that all your system hardware options are installed, you are ready to install SCO.
Go to the Installing and Configuring System Software section to perform this task.