Table of Contents
Advertisement
7-66 Disassembly and Reassembly
6.
Remove the two screws securing the module board to the rear of the CD-ROM/Floppy
Disk assembly. Save the screws.
7.
Release the two cable retainer tabs on the module board and disconnect the two ribbon
cables. Set the defective module aside.
Install the ribbon cables into the replacement module board connectors and secure the
8.
retainer tabs.
Install the module to the CR-ROM/Floppy Disk assembly with the two screws removed
9.
in Step 6.
10.
Insert the Floppy Disk/CD-ROM assembly straight into the flex bay.
11.
Power on the server and verify the replacement module board is working properly.
Screws (2)
Advertisement
Table of Contents
Troubleshooting
