NEC Express5800/120Rd-2 Service Manual page 286

7-42 Disassembly and Reassembly
8. Install the PCI board on the riser card.
Align the PCI board terminal section with the riser card slot, and firmly push the PCI
board until it is fully seated.
Slit in the PCI
board bracket
Embossed
Low-profile type
IMPORTANT:
Do not touch the terminals of the riser cards and PCI boards with your
!
bare hand. Fingerprints and dust left on them cause the server to
malfunction.
If you are unable to install a PCI board correctly, remove it, and then
!
install it again. Be careful not to apply excess force to a PCI board or
riser card. Doing so may damage the card.
NOTES:
Confirm that the slit in the PCI board bracket is positioned by the
!
embossed part. (This applies to other card brackets and extension slot
covers.)
Confirm that the top end of the PCI board bracket is inserted in the
!
designated slot of the riser card.
If a full-height PCI board is installed, confirm that the PCI board
!
bracket and the edge of the opposite card are inserted in the guide rails
of the riser card.
Slit in the PCI
board bracket
Slot
Top end of the
PCI board
Top end of the
bracket
PCI board bracket
Guide rails
Embossed
Slot
Full-height type
Guide rail