NEC Express5800/120Rd-2 Service Manual page 254

7-10 Disassembly and Reassembly
Power on the server, start the SETUP utility, select [Boot] → [Hard Disk], and set the
10.
boot priority in the submenu.
This operation is necessary because installing an additional hard disk drive clears the
current setting of the boot priority.
IMPORTANT:
To add a hard disk during operation of the Global Array Manager
!
(GAM), click the Scan Device key after about 90 seconds have passed
from the installation of the hard disk. If you click the Scan Device key
after executing the Expand Array, the added disk appears correctly.
If a hard disk is added to the server operating in RAID1 by using the
!
expand array feature, the RAID is automatically changed to RAID0+1.
(However, it is not possible to set RAID0+1 directly by using a
specific utility.)
11. Install the front bezel you removed in step 2.
There are tabs on the left side of the front bezel. Engage the tabs with the server frame,
install the front bezel, and lock it with the security key.
Frame
Tabs