Setting Up Your Server - NEC Express5800/120Rd-2 Service Manual

FRONT
Device with the
SCSI interface
*1
USB device
REAR
Display unit
*1 Windows NT 4.0 needs the compliant driver. Any USB keyboard and mouse are not supported.
*2 A leased line cannot be connected directly to this connector.
The console of a management PC can be connected to only serial port 2. (BIOS setting required) Connect the
console to only serial port 2 on either the front or rear panel. This connector is capped for preventing incorrect
connection in the standard status.
*3 Use the provided branch cable.
*4 Connect the power cord to a circuit breaker of 15 A or less.
Be aware of the cable you are going to connect to the server.
NOTE:
!
The "100BASE-TX/10BASE-T connector" and the "serial port 2
connector" of this server are identical. Be careful not to connect a
cable to a wrong connector. Tag cables connected to these ports.
USB device *1
Device with the
*2
serial interface
Mouse
Keyboard
*3
Hub USB device
(multiport repeater)

Setting Up Your Server 2-17

Finally connect the
provided power cord to
Device with the
*2 the receptacle.
serial interface
If connecting the server
to UPS, see the
explanation below.
If an optional power supply
unit is additionally installed,
connect the provided
power cord to this AC inlet
and the receptacle.
*1
Device with
the serial
interface
(e.g.,
Management
*2
PC)
*4
*4