NEC Express5800/120Rd-2 Service Manual page 122

3-32 Configuring Your System
Procedure from Start-up to Exit
The following describes the procedure from starting to exiting the SCSISelect utility. For
parameter descriptions, see the section "Parameters" described later.
1. Power on the Express server.
The following message appears while POST is in progress.
IMPORTANT:
Adaptec AIC-7899 SCSI BIOS V 2.55
(c) 1999 Adaptec, Inc. All Rights Reserved
!!!Press <Ctrl> <A> for SCSISelect(TM) Utility! """
Press and hold Ctrl and A.
2.
The SCSISelect utility starts and its Main menu appears.
3. Select "01:06:A" or "01:06:B" in the "Bus:Device" box with the cursor keys and press
Enter.
You have an AIC-7899
SCSI host adapter in your system. Move
the cursor to the bus:device:channel of
the one to be configured and
press <Enter>.
<F5> - Toggle color/monochrome
The system board is provided with two SCSI controller channels. Channel B (01:06:B)
indicates the Ultra-160/m SCSI connector (for hard disks); and Channel A (01:06:A)
indicates the Wide Ultra 2 SCSI connector (for 5.25-inch devices and external SCSI
devices).
Select the device number in the "Bus:Device" box and press Enter.
The Options menu appears.
Select "Configure/View Host Adapter Settings" and press Enter.
4.
Configure/View Host Adapter Settings
The message appears for each additional SCSI controller.
Options
SCSI Disk Utilities
Bus:Device:Channel
01:06:A
01:06:B