Standard Features - NEC Express5800/120Rd-2 Service Manual

1-16 System Overview

STANDARD FEATURES

High performance
 
! Intel
Pentium III Processor
(1GHz/1.26GHz-S)
! High-speed 100BASE-TX/10BASE-T
interface (100Mbps/10Mbps supported)
! High-speed disk access
(Ultra160 SCSI x 2)
! High-speed memory access (133MHz,
ECC, registered, PC/133 compliant, 72-
bit, 68-pin, 3.3V)
High-reliability
! Memory monitoring feature (1-bit error
correction/ 2-bit error detection)
! CPU/memory degradation feature
(logical isolation of a failed device)
! Bus parity error detection
! Temperature detection
! Error notification
! Internal fan monitoring feature
! Internal voltage monitoring feature
! Auto-rebuild feature (optional, hot-
swappable)
! BIOS password feature
! Mechanical security lock
! Redundant power supply (hot-swap)
Management Utilities
! NEC ESMPRO
! NEC Management Workstation
Application (NEC MWA)
Maintenance Features
! Off-line Maintenance Utility
! Memory dump feature using the DUMP
switch
Expandability
! Three full-length, full-height 64-bit/66-
MHz PCI riser slots and three low profile
64-bit/66-MHz riser slots
! Large memory of up to 6 GB
! Seven hot-swap SCSI hard disk drive
bays
! Up to two multi-processors are available
for upgrade.
! One backup file bay
! Flex bay
! USB interface (A USB-support driver is
required.)
! Two network ports
Many Available Features
! Graphic accelerator "RAGE XL" support
! Bootable CD-ROM (no emulation mode)
format support
! POWER switch mask
! Software power-off
! Remote power-on feature
! AC-LINK feature
! Baseboard Management Controller
(BMC)
! Consoleless feature
Self-diagnosis
! Power On Self-Test (POST)
! Test and Diagnosis (T&D)
Easy and Fine Setup
! NEC EXPRESSBUILDER (system setup
utility)
! Configuration Parameter Diskette Creator
! SETUP (BIOS setup utility)
! SCSISelect (SCSI device utility)