NEC Express5800/120Rd-2 Service Manual page 191

Installing the Intel PRO/100+ LAN Card Driver from a Diskette
The driver for the Intel PRO/100+ LAN card is generated from the E
CD.
To load an Intel PRO/100+ LAN card driver, insert the Intel PRO/100+ Driver
diskette into your disk drive and logon to the SCO Open Server graphical interface.
Use the following procedure to install the driver.
1. Select the Software Manager icon from the Main Menu display.
2. Within the menu bar click on Software. A pull-down menu displays.
3. Select Install New. A dialog box displays asking if you are installing the driver
from the host system or another host.
4. Highlight the host system in which the driver media is installed and press ENTER
(click on Continue).
5. A dialog box displays asking for the media device used for this installation. Select
the media device (usually the floppy diskette drive) and press ENTER (click on
Continue).
6. A dialog box displays the driver(s) read from the media. Select the appropriate
driver and press ENTER (click on Full).
7. A dialog box appears. Please use netconfig to configure network software, press
return to continue. Press ENTER.
8. A message dialog box displays indicating "Installation complete." Press ENTER
or select OK.
9. The Software Manager displays the loaded driver.
Select Exit from the Host pull down menu.
Configuring the Intel PRO/100+ LAN Card
1. Select the System Administration icon from the Main Menu display.
2. Select the Networks icon.
3. Select the Network Configuration Manager.
4. Select the Hardware Options pull-down menu and choose Add New LAN Adapter.
5. Highlight the card to be installed.
6. Select Continue.
7. When the Add Protocol menu is displayed select SCO TCP/IP, then select ADD.
8. Enter the required information to configure TCP/IP, then select OK. Refer to the
SCO OpenServer Handbook, Appendix A, TCP/IP Configuration Parameters.
Installing the Operating System 4-57
B
XPRESS UILDER