Connecting The Power Cord - NEC Express5800/120Rd-2 Service Manual

CONNECTING THE POWER CORD

Connect the provided power cord to the server.
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury.
Do not hold the power plug with a wet hand.
Do not connect the ground wire to a gas pipe.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage.
Do not plug the power cord in to an improper power source.
Do not connect the power cord to an outlet that has an illegal number of
connections.
Insert the power plug into the outlet as far as it will go.
Use an authorized power cord only.
1. Plug the provided power cord into the power receptacle on the rear of the server.
2. Plug the other end of the power cord into the wall outlet.
IMPORTANT:
WARNING
CAUTION
Secure the power cord with a tie wrap.
Setting Up Your Server 2-19