Console Redirection - NEC Express5800/120Rd-2 Service Manual

3-24 Configuring Your System

Console Redirection

Select "Console Redirection" on the Server menu and press Enter to display the following
screen.
See the table below for setup options on the screen.
Option Parameter
Serial Console [Disabled]
Redirection Enabled
Serial Port COM1 3F8 IRQ4
COM2 2F8 IRQ3
Baud Rate 9600
[19.2k]
38.4k
115.2k
Flow Control No Flow Control
[CTS/RTS]
XON/XOFF
CTS/RTS+CD
Description
Specifies whether BIOS uses the
specified serial port to redirect the
console to MWA or remote terminals
using hyper terminal. Disable the Quiet
Boot option in BOOT menu.
Selects an address/interrupt for the serial
port used for redirection.
Make sure to use the same
address/interrupt as specified in
[Advanced] - [Peripheral Configuration].
Selects a baud rate for communications
with the connected HW console.
[56k] is not available.
Select a flow control method.
Your Setting
[ ]: Factory-set